Multi-Aperture cores (2843000202)
Part Number: 2843000202
43 MULTI-APERTURE CORE
Explanation of Part Numbers:
– Digits 1 & 2 = Product Class
– Digits 3 & 4 = Material Grade
– Last digit 2 = Burnished
Multi-aperture cores are used in suppression applications and in balun (balance-unbalance) and other broadband transformers. They are also employed in airbag designs to prevent accidental activation.
All multi-aperture cores are supplied burnished.
Our “Multi-Aperture Core Kit” (part number 0199000036) is available for prototype evaluation.
For any multi-aperture requirement not listed here, feel free to contact our customer service group for availability and pricing.
Weight: 3.7 (g)
|Dim||mm||mm tol||nominal inch||inch misc.|
|Typical Impedance (Ω)|
Multi-aperture cores in 73 and 43 materials are controlled for impedance only. The 61 NiZn material is controlled for both impedance and AL value. The high frequency 67 material is controlled for AL value. Minimum impedance values are specified for the + marked frequencies. The minimum impedance is typically the listed impedance less 20%.
Multi-aperture cores in 73 and 43 material are measured for impedance on the E4990A Impedance Analyzer. The 61 and 67 multi-aperture cores are tested on the E4991A / HP4291B Impedance Analyzer. All impedance measurements are performed with a single turn to both holes, using the shortest practical wire length.
The 61 and 67 material multi-hole beads are tested for AL value. The test frequency is 10 kHz at < 10 gauss. The test winding is five turns wound through both holes.
This NiZn is our most popular ferrite for suppression of conducted EMI from 20 MHz to 250 MHz. This material is also used for inductive applications such as high frequency common-mode chokes.
Available in 43 material:
EMI Suppression Beads
Beads On Leads
Round Cable EMI Suppression Cores
Round Cable Snap-Its
Flat Cable EMI Suppression Cores
Flat Cable Snap-Its
Miscellaneous Suppression Cores
43 Material Characteristics
|Initial Permeability@ B < 10 gauss||µi||800|
|Flux Density @ Field Strength||Gauss
|Residual Flux Density||Gauss||Br||2200|
|Loss Factor @ Frequency||10 -6
|Tan δ/ µi||100
|Temperature Coefficient of Initial Permeability (20 -70°C)||%/°C||1.25|
**** Characteristic curves are measured on standard Toroids (18/10/6 mm) at 25°C and 10 kHz unless otherwise indicated. Impedance characteristics are measured on standard shield beads (3.5/1.3/6.0 mm) unless otherwise indicated.